Zoom MRS-1608 Operation Manual page 164

Reference [Creating a CD]
NOTE
If the backup of the project spans multiple discs, be sure to
insert the first disc that contains data of the desired project
first. If you insert another disc, the project data will not be
read correctly.
5.
Press the [ENTER] key.
The name of the project on the disc, and the number
which is to be assigned to the project are shown on the
display.
LOAD LOAD
PRJ012 PRJ012
Project name Project number to be assigned
HINT
When being restored to the MRS-1608, an empty project
number is automatically assigned to the project. Even if a
project with the same name already exists on the hard disk,
it will not be overwritten.
6.
To check the name of the folder from which
the project will be read, press the cursor
down key.
The second line of the display shows the folder name.
Press the cursor up key to restore the original display.
7.
Turn the dial to select the project to load,
and press the [ENTER] key.
The indication "LOAD SURE?" appears on the display.
8.
To execute the load operation, press the
[ENTER] key. To cancel, press the [EXIT]
key instead.
When you press the [ENTER] key, the indication
"Wait..." appears on the display. When the operation is
finished, the display indication changes to "LOAD
COMPLETE", and the CD-R/RW disc is ejected.
If the backup spans multiple discs, the CD-R/RW disc
will be automatically ejected after the data have been
loaded, and the display indication changes as follows.
CHANGE CHANGE
DISC002 DISC002
164
PRJ 007 PRJ 007
When this message is shown, insert the next CD-R/RW
disc, and press the [ENTER] key. The load operation
resumes. Repeat this operation until the last disc of the
project has been read.
NOTE
If the backup of the project spans multiple discs, be sure to
insert the discs in the correct order. Otherwise the project
data will not be read correctly.
HINT
When the disc has been ejected, it is possible to abort the
load operation. To do this, press the [EXIT] key while the
indication "CHANGE DISCxxx" (where xxx is the disc
number) is shown. The indication will change to "LOAD
CANCEL?". Press the [ENTER] key to terminate the process.
9.
To return to the main screen, press the
[EXIT] key several times.
ZOOM MRS-1608