Zoom MRS-1608 Operation Manual page 105

INSERT? INSERT?
P001x 2 P001x 2
Rhythm pattern
number to insert
In this condition, you can insert rhythm pattern
information.
5.
Turn the dial to select the rhythm pattern
that you want to insert.
6.
Use the cursor up/down keys to specify the
number of measures to insert.
If you specify more measures than the original length of
the rhythm pattern, the rhythm pattern will be repeated. If
you specify fewer measures, the song will switch to the
next rhythm pattern before the current pattern has
finished playing.
7.
To finalize the setting, press the [ENTER]
key.
The rhythm pattern information will be input at the
current location, and the display reverts to the original
screen. The "EOS" indication is moved back by the
number of measures that were inserted.
By pressing the PLAY [
shown, you can check the rhythm pattern entered at the
current point.
PTN 002 PTN 002
08Beat03 08Beat03
Current position
(measure
1 2
number)
Song
PATTERN 002
8.
Repeatedly press the cursor right key to
move to the measure number for which
"EOS" is shown.
During step input, you can use the cursor left/right keys
to move the input position in measure units. When you
reach the end of the song, the indication "EOS" is shown
on the second line of the display.
ZOOM MRS-1608
Number of measures
to insert
R
] key while this display is
001 1 1 0 0 001
3
End of Song
PTN PTN
EOS EOS
(measure
1 2
number)
Song
PATTERN 002
HINT
• The REW [T] and FF [Y] keys in the transport section can be
used to move the current position in beat units.
→
• When "EV " is shown on the display, turning the dial moves
the current position in sixteenth note units. By bringing up the
→
"EV " indication to move to a point within a measure and
then using the cursor up/down keys to display event
information, you can enter event information in sixteenth note
→
units ( p. 108).
9.
Repeat steps 4 – 8 to enter all required
pattern information.
10.
When all required pattern information has
been entered, press the STOP [
O
The REC [ ] key goes out and the rhythm song selection
screen appears again. If you press the PLAY [
created rhythm song will be played.
To edit the entered rhythm pattern information, proceed
as follows.
●
Selecting a different rhythm pattern
Use the cursor left/right keys to move to the point where
the respective rhythm pattern information is input, and
then turn the dial to select the new rhythm pattern.
Select pattern D
PATTERN A PATTERN B
PATTERN A PATTERN D
By turning the dial at a point where no rhythm pattern
information is input ("
new rhythm pattern information for this point.
In any case, the newly selected rhythm pattern
information will be valid until the point where the next
rhythm pattern information is input.
Reference [Rhythm]
003 1 1 0 0 003
Current position
3
End of Song
P
] key.
R
] key, the
PATTERN C
PATTERN C
PTN" is shown), you can add
105