Zoom MRS-1608 Operation Manual page 60

Reference [Track Editing]
2.
Use the cursor up/down keys and the dial/
status keys to select the track/V-take to be
used as destination.
If you specify the same track/V-take as the source, the
harmony data will be added to the original data and the V-
take will be overwritten. You can also specify a stereo
track or two mono tracks as destination.
3.
Press the [ENTER] key.
The display indication changes as follows. From this
screen, you can set the key to be used as reference for the
harmony.
DUO HARM DUO HARM
KEY KEY
4.
Turn the dial to select the key.
The setting range is C - B (in semitone steps).
5.
Use the cursor left/right keys to bring up
the indication "DUO HARM SCALE" on the
display. Then turn the dial to select the
scale type and the pitch shift direction. The
following settings are available.
Create harmony a major third up
• Maj Up:
• Min Up: Create harmony a minor third up
• Maj Dn: Create harmony a major third down
• Min Dn: Create harmony a minor third down
DUO HARM DUO HARM
SCALE SCALE
6.
Use the cursor left/right keys to bring up
the indication "FEELING" on the display.
Then turn the dial to select the speed with
which the created harmony will reach the
target pitch.
The setting range is 0 – 30. The larger the value, the
smoother the transition to the harmony.
DUO HARM DUO HARM
FEELING FEELING
60
C
Key
Maj Up Maj Up
7
7.
Use the cursor left/right keys to bring up
the indication "SOURCE LVL" on the
display, and turn the dial to set the volume
for the edit source.
The setting range is 0 – 127. A setting of 100 results in an
unchanged level.
DUO HARM DUO HARM
SOURCE SOURCE
HINT
When the SOURCE LVL parameter is set to zero, the edit
source will be muted, and only the generated harmony is
written to the track.
8.
To set the pan value for the edit source, use
the cursor left/right keys to bring up the
indication "SOURCE Pan" on the display,
and then turn the dial to adjust panning for
the source.
The setting range is L100 (fully left) - 0 (center) - R100
(fully right).
DUO HARM DUO HARM
SOURCE SOURCE
NOTE
When the destination is a mono track, the pan setting will
have no effect.
9.
Adjust the level and panning for the
harmony part in the same way, by bringing
up the indication "CHORUS LVL" or
"CHORUS Pan" on the display.
.
10
Press the cursor down key to cause the
counter indication to flash. Then use the
cursor left/right keys and the dial to specify
the start point for Duo Harmony generation.
You can also use the MARKER [
U T
[ ] key, and REW [ ]/FF [
The Duo Harmony part will be added to the range where
recording steps were carried out. By pressing the PLAY
R
[ ] key at this point, you can check the editing result.
LVL 100 LVL 100
Pan Pan 0 0
U I
]/[ ] keys, ZERO
Y
] keys to locate the point.
ZOOM MRS-1608