Loading Originals In The Document Processor - Kyocera TASKalfa 181 Operation Manual

Preparation before Use

Loading Originals in the Document Processor

The optional document processor automatically scans each sheet of multiple originals. Both sides of two-sided
originals are scanned.
Originals Supported by the Document Processor
The document processor supports the following types of originals.
• Sheet originals only
• Paper weight
One-sided originals: 45 g/m² to 160 g/m²
Two-sided originals: 50 g/m² to 120 g/m²
• Sizes: A3 to A5R, Folio, 11 × 17" (Ledger) to 5
• Number of originals: 50 sheets (50 g/m² to 80 g/m²) (30 sheets for auto selection mode)
Originals Not Supported by the Document Processor
Do not use the document processor for the following types of originals.
• Soft originals such as vinyl sheets
• Transparencies such as OHP film
• Carbon paper
• Originals with very slippery surfaces
• Originals with adhesive tape or glue
• Wet originals
• Originals with correction fluid which is not dried
• Irregularly shaped (non-rectangular) originals
• Originals with cut-out sections
• Crumpled paper
• Originals with folds (Straighten the folds before loading. Failure to do so may cause the originals to jam).
• Originals bound with clips or staples (Remove the clips or staples and straighten curls, wrinkles or creases
before loading. Failure to do so may cause the originals to jam).
Part Names of the Document Processor
3
2-26
1
4
2 2
7
6
× 8 " (Statement)
1/2 1/2
(1) Original table
5
(2) Original insert guides
(3) Left cover
(4) Original eject table
(5) Ejection extension
(6) Document processor release grip
(7) Ejection tray
OPERATION GUIDE