Responding To Error Messages - Kyocera TASKalfa 181 Operation Manual

Responding to Error Messages

If the touch panel displays any of these messages, follow the corresponding procedure.
Alphanumeric
Error Message
Add paper in
cassette.
## size (###)
Add paper in
cassette.
[Place paper in P
cassette.]
Call for service.
Cannot staple this
size.
[Cannot staple
this pap. Size]
Checksum Error
Check paper size.
OPERATION GUIDE
Checkpoints
Print data does not match
the size or type of paper in
the cassette. Replace the
paper.
Paper has run out.
—
Stapling of small paper,
such as 5 × 8 "
1/2 1/2
(Statement), A5-R, and B5-
R, is not possible.
The machine has detected
an error at startup.
There is no paper loaded
of a size that can be used
in the currently selected
mode.
Corrective Actions
To change the paper source, press
the Paper Selection key to select the
desired paper source, and then press
the Enter key.
If you press the Print key, the
following messages are displayed.
GO: Prints onto the currently selected
paper.
CANCEL: Stops printing.
Press to select the desired
or
processing, and then press the Enter
key.
Add paper.
Open the front cover once and close
it. If the message is displayed again,
check C and the number. Turn the
main power switch off and contact
your service representative or
authorized service center.
Turn off the main power switch and
on again. If the same message
appears, contact your service
representative or authorized service
center.
Check the paper.
Troubleshooting
Reference
Page
—
2-14
9
—
—
—
—
9-5