Kyocera TASKalfa 181 Operation Manual page 218

Troubleshooting
Symptom
Printouts are
wrinkled.
Cannot print.
Correct characters
are not printed.
Documents are
printed improperly.
While the operation
panel was being used,
the keys locked up
and do not respond
when pressed.
9-4
Checkpoints
Is the paper separator of the
paper feed unit dirty?
Is the paper damp?
Is the paper set in a proper
orientation?
Is the machine plugged in?
Is the machine powered on?
Is the printer cable
connected?
Was the machine powered
on before the printer cable
was connected?
Is the machine offline? (Is the
Ready indicator off?)
Is a proper printer cable
connected?
Are the application software
settings at the PC set
properly?
Is the operation panel
locked?
Corrective Actions
Clean the paper separator.
Replace the paper with new paper.
Change the orientation in which the
paper is positioned.
Plug the power cord into an AC
outlet.
Turn on the main power switch.
Connect the correct printer cable
securely.
Power on the machine after
connecting the printer cable.
Press the Print key,
select GO, and then press the Enter
key. The Ready indicator lights up.
Connect a shielded type printer
cable.
Check that the printer driver and
application software settings are
set properly.
Check the panel lock setting in
COMMAND CENTER and change
the setting if necessary.
Reference
Page
8-3
2-14
—
—
3-2
2-5
3-2
to —
or
2-5
—
KYOCERA
COMMAND
CENTER
Operation
Guide
OPERATION GUIDE