Program Function - Kyocera TASKalfa 181 Operation Manual

Copying Functions

Program Function

After registering sets of frequently used functions as a single program, you can simply press the program
number as needed to recall those functions. You can also name the programs for easy identification when
recalling.
Registering Programs
Use the procedure below to register a program.
The following procedure is an example of registering the copying function.
Program:
Program #7
Program #8
Register program .
Register program :
Program #1
Program #2
Program #3
Recalling Programs
Use the procedure below to recall a registered program.
Program:
Program #1
Program #2
Program #3
4-32
1
Press the Program key while the copy mode is
accessed.
2
Press or to select Register program, and
then press the Enter key.
NOTE:
If you select a program number already
registered, the currently registered functions can be
replaced with a new set of functions.
3
Press to select the program number to
or
register (1 to 8), and then press the Enter key.
The program is registered.
NOTE:
You can also select the program number using
a numeric key.
1
Press the Program key.
2
Press to select the program number to
or
recall, and then press the Enter key.
NOTE:
You can also select the program number using
a numeric key.
3
Place the originals and press the Start key.
Copying starts with the settings that were
registered.
OPERATION GUIDE