Margin Mode - Kyocera TASKalfa 181 Operation Manual

Copying Functions

Margin Mode

Shift the original image to make space on the copy for binding on the left (right) or top (bottom) side.
The following margin widths are available.
Inch Models
Metric Models
NOTE:
You can set the default margin width. Refer to Margin Width Default Value on page 6-10 for details.
Use the procedure below to make copies with margins.
Margin:
Left Margin
Top Margin
Margin Width :
1/4"
4-22
Input units
1/8 to 3/4" (in 1/8" increments)
1 mm to 18 mm (in 1 mm increments)
1/8" 3/4"
Margin Width
1
Press the Copy key.
2
Place the originals on the platen.
3
Press the Margin key to select the copy with
margin.
4
Press or to select Left Margin or Top
Margin, and then press the Enter key.
5
Press or to set the margin width, and then
press the Enter key.
You can set the width to 1/8" to 3/4" in 1/8"
increments [1 mm to 18 mm in 1 mm increments].
6
Press the Start key to start copying.
OPERATION GUIDE