Loading Originals In The Document Processor - Kyocera 7056i Operation Manual

Operation on the Machine > Loading Originals
IMPORTANT
• Do not push the document processor forcefully when you close it. Excessive pressure may crack the platen
glass.
• When placing books or magazines on the machine, do so with the document processor in the open position.

Loading Originals in the Document Processor

The document processor automatically scans each sheet of multiple originals. Both sides of two-sided originals are
scanned.
The document processor supports the following types of originals.
Detail
Weight
Sizes
No. of sheets
Do not use the document processor for the following types of originals. Otherwise, the originals may be jammed or the
document processor may become dirty.
• Originals bound with clips or staples (Remove the clips or staples and straighten curls, wrinkles or creases before
loading. Failure to do so may cause the originals to jam.)
• Originals with adhesive tape or glue
• Originals with cut-out sections
• Curled original
• Originals with folds (Straighten the folds before loading. Failure to do so may cause the originals to jam.)
• Carbon paper
• Crumpled paper
IMPORTANT
• Before loading originals, be sure that there are no originals left on the original eject table. Originals left on
the original eject table may cause the new originals to jam.
• Do not make an impact on the document processor top cover, such as aligning the originals on the top
cover. It may cause an error in the document processor.
1
2
35 to 220 g/m (duplex: 50 to 220 g/m
Sizes smaller than B6-R are 50 to 105 g/m
Maximum A3/Ledger (11.69" × 17"/ 297 × 432 mm) (Long-sized 11.69" × 86.62"/
297 × 2,200 mm) to Minimum A6-R/Statement-R (4.13" × 5.82"/105 × 148 mm)
2
Plain paper (80 g/m ), Recycled paper, Vellum paper: 270 sheets
(Mixed size originals: 30 sheets)
2
Thick paper (120 g/m ): 180 sheets
Art paper: 1 sheet
Adjust the original width guides.
Document Processor
2
)
2
(1-side/duplex)
5-3