Kyocera TASKalfa 181 Operation Manual page 253

Transparencies
Transparencies must be able to withstand the heat of printing. Transparencies must meet the following
conditions.
Heat resistance
Thickness
Material
Dimensional accuracy
Squareness of corners
To avoid problems, use the MP tray for transparencies and load transparencies with the long side facing the
machine.
If transparencies jam frequently at output, try pulling the leading edge of sheets gently as they are ejected.
Hagaki
Burrs
Envelopes
Use the MP tray for envelopes.
Due to the structure of envelopes, printing evenly over the entire surface may not be possible in some cases.
Thin envelopes in particular may be wrinkled by the machine in some cases as they pass through. Before
purchasing envelopes in volume, try testing a sample to ensure the print quality.
Storing envelopes for a long period may cause them to become wrinkled. Thus, keep the package sealed until
you are ready to use them.
Keep the following points in mind.
Do not use envelopes with exposed adhesive. In addition, do not use the type of envelope in which the adhesive
is exposed after the top layer is peeled off. Serious damage may be caused if the paper covering the adhesive
comes off in the machine.
Do not use envelopes with certain special features. For example, do not use envelopes with a grommet for
winding a string to close the flap or envelopes with an open or film-covered window.
If paper jams occur, load fewer envelopes at once.
OPERATION GUIDE
Criteria
Must withstand at least 190°C
0.100 to 0.110 mm
Polyester
±0.7 mm
90° ±0.2°
Before loading Hagaki into the MP tray, fan them and
align the edges. If the Hagaki paper is curled, straighten
Burrs
it before loading. Printing onto curled Hagaki may cause
jams.
Use unfolded Oufuku Hagaki (available at post offices).
Some Hagaki may still have rough edges developed by
a paper cutter on the back side. Remove any such
rough edges by placing the Hagaki on a flat surface and
rubbing the edges gently a few times with a ruler.
Specifications
Appendix-15