Loading Originals In The Document Processor - Kyocera ECOSYS M3645idn Operation Manual

Operation on the Machine > Loading Originals

Loading Originals in the Document Processor

The document processor automatically scans each sheet of multiple originals. Both sides of two-sided originals are
scanned.
Originals Supported by the Document Processor
The document processor supports the following types of originals.
Weight
Sizes
No. of sheets
Originals Not Supported by the Document Processor
Do not use the document processor for the following types of originals. Otherwise, the originals may be jammed or the
document processor may become dirty.
• Originals bound with clips or staples (Remove the clips or staples and straighten curls, wrinkles or creases before
loading. Failure to do so may cause the originals to jam.)
• Originals with adhesive tape or glue
• Originals with cut-out sections
• Curled original
• Originals with folds (Straighten the folds before loading. Failure to do so may cause the originals to jam.)
• Carbon paper
• Crumpled paper
How to Load Originals
IMPORTANT
• Before loading originals, be sure that there are no originals left on the original eject table. Originals left on
the original eject table may cause the new originals to jam.
• Do not make an impact on the document processor top cover, such as aligning the originals on the top
cover. It may cause an error in the document processor.
1
2
50 to 120 g/m
2
(duplex: 50 to 120 g/m )
Maximum 216 x 355.6 mm (Long-sized 216 x 915 mm) to Minimum 105 x 148 mm
ECOSYS M3145idn/ECOSYS M3645idn: 75 sheets or less (50 to 80 g/m
ECOSYS M3655idn/ECOSYS M3660idn: 100 sheets or less (50 to 80 g/m
Adjust the original width guides.
5-3
2
)
2
)