Loading Originals In The Document Processor - Kyocera ECOSYS MA4500fx Operation Manual

Operation on the Machine > Loading Originals
CAUTION
Do not leave the document processor open as there is a danger of personal injury.
IMPORTANT
• Do not push the document processor forcefully when you close it. Excessive pressure may crack the
platen glass.
• When placing books or magazines on the machine, do so with the document processor in the open
position.

Loading Originals in the Document Processor

The document processor automatically scans each sheet of multiple originals. Both sides of two-sided originals
are scanned.
Originals Supported by the Document Processor
The document processor supports the following types of originals.
Weight
Sizes
No. of sheets
Originals Not Supported by the Document Processor
Do not use the document processor for the following types of originals. Otherwise, the originals may be jammed
or the document processor may become dirty.
• Originals bound with clips or staples (Remove the clips or staples and straighten curls, wrinkles or creases
before loading. Failure to do so may cause the originals to jam.)
• Originals with adhesive tape or glue
• Originals with cut-out sections
• Curled original
• Originals with folds (Straighten the folds before loading. Failure to do so may cause the originals to jam.)
• Carbon paper
• Crumpled paper
How to Load Originals
IMPORTANT
• Before loading originals, be sure that there are no originals left on the original eject table. Originals
left on the original eject table may cause the new originals to jam.
• Do not make an impact on the document processor top cover, such as aligning the originals on the top
cover. It may cause an error in the document processor.
1
Adjust the original width guides.
2
50 to 120 g/m
2
(duplex: 50 to 120 g/m )
Maximum 216 x 355.6 mm (Long-sized 216 x 915 mm) to Minimum 105 x 148 mm
75 sheets or less (50 to 80 g/m
2
)
5-3