Loading Originals In The Document Processor - Kyocera ECOSYS M2040dn Operation Manual

Operation on the Machine > Loading Originals

Loading Originals in the Document Processor

The document processor automatically scans each sheet of multiple originals. Both sides of two-sided originals are
scanned. (Only on models with a duplex scanning function.)
The document processor supports the following types of originals.
Weight
Sizes
No. of sheets
*1 Only on models with a duplex scanning function.
Do not use the document processor for the following types of originals. Otherwise, the originals may be jammed or the
document processor may become dirty.
• Originals bound with clips or staples (Remove the clips or staples and straighten curls, wrinkles or creases before
loading. Failure to do so may cause the originals to jam.)
• Originals with adhesive tape or glue
• Originals with cut-out sections
• Curled original
• Originals with folds (Straighten the folds before loading. Failure to do so may cause the originals to jam.)
• Carbon paper
• Crumpled paper
IMPORTANT
• Before loading originals, be sure that there are no originals left on the original eject table. Originals left on
the original eject table may cause the new originals to jam.
• Do not make an impact on the document processor top cover, such as aligning the originals on the top
cover. It may cause an error in the document processor.
1
50 to 160 g/m
(duplex: 50 to 160 g/m
Maximum Folio (Legal) to Minimum A6 (Statement)
Plain paper (80 g/m
Thick (120 g/m
Open the original table and then adjust the original width
guides.
2
2 *1
)
2
): 50 sheets (Mixed size originals: 50 sheets)
2
): 25 sheets
5-3