Table of Contents
Advertisement
When you try to load single-sheet paper manually, the printer
loads the paper from the cut-sheet feeder.
Cause
The paper was not properly
loaded in the front paper
guide.
One page of your document is printed on two pages.
Cause
The paper size setting in your
application software does not
match the size of the paper
loaded in the printer.
The printer does not load the paper you want when you
switch between the cut-sheet feeder and the tractor.
Cause
The paper release lever is set
incorrectly.
Operation
The Pause light is off but the printer does not print.
Cause
The interface cable is not
plugged in securely.
What to do
Load the paper in the front paper
guide as described on page 3-7.
What to do
Adjust the paper size setting in your
application or the printer driver.
What to do
Set the paper release lever correctly.
for tractor feeding,
feeding and
for clearing a paper
jam.
What to do
Check that both ends of the cable
between the printer and the computer
are plugged in securely. If the cable is
connected correctly, run a self test as
described on page 8-5.
Troubleshooting
for single-sheet
8-17
8
Advertisement
Table of Contents
