Table of Contents
Advertisement
T-margin tractor, manual (rear and forward), and CSF
You can set different top margins for paper loaded with the push
tractor, by manual feed, and with the optional cut-sheet feeder.
Note:
When loading from the cut-sheet feeder in Cards and Envelopes
modes, the SelecType "T-Margin CSF" setting value should be
automatically set to 4.2 mm or more.
Character table
Character tables contain characters and symbols used in
different languages. Your printer has the following character
tables. See Appendix B for specific characters in each table.
The character tables you can choose depend on the current
printer mode set in the Software setting in SelecType Level 2.
The display shows character tables available only in the current
printer mode.
Page tractor
You can set the page length of continuous paper loaded in the
push tractor.
If you select Other, you enter a submenu in which you can set
the page length in 1/6-inch line increments. Press the d button
or the u button until the display shows your desired line
setting. Then press the r button to make this the new setting.
Page CSF
You can set the page length of single sheets loaded in the
optional cut-sheet feeder (CSF).
Controlling the Printer
4
4-13
Advertisement
Table of Contents
