Table of Contents
Advertisement
The binding area should be flat and have no creases.
The sprocket holes of all sheets in the form should be aligned
properly.
The binding position should be outside the printable area.
Dimensions and
Printable area
Labels
Labels should be securely attached to the backing sheet and the
label surface must be flat.
The labels should not peel off their backing sheet under the
conditions below.
When using labels whose backing sheet is entirely covered, make
sure the cuts around the edges of the labels are perforated.
label sheet
backing sheet
When using labels whose backing sheet is not covered with the
label material, see the illustration below and do not set the paper
thickness lever to the AUTO position, set it manually.
label
backing sheet
A-8
Specifications
See page A-4–5 for single-sheet multi-part forms
See page A-6–7 for continuous multi-part forms
label
27 mm
wrapping drum radius
wrapping angle
wrapping time
ambient temperature
ambient humidity
label
label
27 mm
180
24 hours
40 C
30%
several uncut areas
on each side
corner radius is
2 to 3 mm
Advertisement
Table of Contents
