Procedure 3 Connection Check; Procedure 3 - Toshiba Satellite Pro M10 Series Maintenance Manual

2.3 Power Supply Troubleshooting

Procedure 3

Connection Check
The power supply wiring diagram is shown below:
AC power cord
Any of the connectors may be disconnected. Perform Check 1.
Check 1 Disconnect the AC power cord from wall outlet. Check the power cable for breaks.
If the power cord is damaged, connect a new AC power cord. If there is no damage,
go to Check 2.
Check 2 Make sure the AC adaptor cord and AC power cord are firmly plugged into the DC IN
15 V jack, AC adaptor inlet and wall outlet. If these cables are connected correctly,
go to Check 3.
Check 3 Make sure that the DC IN jack is firmly secured to the system board.
• If the DC IN jack is loose, go to Procedure 5.
• If it is not loose, go to Check 4.
Check 4 Use a multimeter to make sure that the AC adaptor output voltage is close to 15 V. If
the output is several percent lower than 15 V, go to Check 5. If the output is close to
15 V, go to Check 6.
Check 5 Connect a new AC adaptor or AC power cord.
• If the DC IN LED does not light, go to Procedure 5.
• If the battery LED does not light, go to Check 6.
Check 6 Make sure the battery pack is installed in the computer correctly. If the battery is
properly installed and the battery LED still does not light, go to Procedure 4.
Satellite Pro M10 Series Maintenance Manual (960-431)
AC adaptor cord
AC
DC-IN
adaptor
Jack
2 Troubleshooting Procedures
System board
PJ8800 PJ8810
PJ117
Slim Select Bay
2nd battery pack
Main battery pack
2-15