4 Replacement Procedures
4.20 VGA Board
Removing the VGA Board
To remove the VGA board, follow the steps below and refer to Figure 4-42.
1. Remove three M2×4 screws securing the VGA board.
2. Gently lift up the VGA board to disconnect it from PJ100 on the system board.
VGA board's connector
PJ100
VGA board
Installing the VGA Board
To install the VGA board, follow the steps below and refer to Figure 4-42.
1. Seat the VGA board and connect it to PJ100 on the system board.
2. Secure the VGA board with three M2×4 screws.
4-62
Figure 4-42 Removing the VGA board
Satellite Pro M10 Series Maintenance Manual (960-431)
4.20 VGA Board
M2 4 screws