4.33 TFT FL (Model 15.0 SXGA+ SHARP LQ150F1LH43)
13. Connect the FPC to the connector on the source PCB.
Pin*
Screw
* Align the holes on the PCBs with the pins.
Figure 4-121 Securing the PCBs and connecting the FPC
Satellite Pro M10 Series Maintenance Manual (960-431)
Source PCB
NG: The FPC does not connect firmly.
Tighten the screws with 0.9 kgf•cm of torque.
4 Replacement Procedures
Make sure the latch secures the connector correctly.
See the notches on both the edge of the FPC, and
see the contour of the connector.
Insert the FPC into the connector firmly. The FPC
must have no inclination. Lock the connector firmly.
NG: The FPC has inclination.
Pin*
FPC
Gate PCB
Screw
Screw
Pin*
Do not let the PCB lie
on the rib of the frame.
Screw
4-149