Toshiba Satellite Pro M10 Series Maintenance Manual page 197

3.28 SETUP
For most printers, the port should be set to ECP. With some other parallel
devices, the setting should be Std. Bi-Direct.
11. Drives I/O
This option displays the address and interrupt level for hard disk drive, CD/DVD-
ROM drive and PC card. It is for information only and cannot be changed.
(a) Built-in HDD
Primary IDE (1F0H/IRQ14)
No Drive
(b) Select Bay
This option is displayed only when the hard disk drive or optical disk drive is
installed to the select bay. Secondary IDE (170H/IRQ15) Computer
Selectable Bay HDD.
(c) PC Card
When an ATA card is installed in IN13h, the sub window below is displayed.
Built-in HDD
ATA Card
12. PCI Bus
This item displays the interrupt level for the Card Bus. It is for information only and
cannot be changed.
PCI BUS = IRQ10, IRQ11
13. PC Card
This option displays the PC Card Controller mode. It is for information only and
cannot be changed.
Controller Mode = Auto-Selected
Satellite Pro M10 Series Maintenance Manual (960-431)
OPTIONS
DMA = Channel 3 (Default)
The Built-in HDD is ready for use.
The Built-in HDD is not installed.
DRIVES I/O
= Primary IDE (1F0H/IRQ14)
= Others (190H/IRQ)
3 Tests and Diagnostics
3-91