Lan Ip Dscp Move - Fujitsu XG Series User Manual

XG Series User's Guide
Default
5.5.1.7

lan ip dscp move

Function
Available Model
Syntax
Options
Use Mode
Explanation
- For ACL to set ICMP
Result of multiplication between the number of ICMP TYPEs and the number of
ICMP CODEs for ICMP
- For ACL not to set TCP, UDP, or ICMP
1
You can expand the upper limit to use
resource distribution.
Note 4.
Up to 700 commands can be set for the entire device, including the definitions which refer
to ACL such as "ether macfilter",
"vlan qos aclmap", "vlan ip6qos
ip6 dscp" and "serverinfo filter" commands.
It is assumed that DSCP value rewriting is not performed.
Change the priority of DSCP value rewriting conditions.
XG0224 / XG0448 / XG2600
lan [<number>] ip dscp move <count> <new_count>
<number>
• lan definition number
Specify a lan definition serial number with a decimal value.
The default is 0.
<count>
• Target DSCP value rewriting definition number
Specify a DSCP value rewriting definition number before the priority was changed.
<new_count>
• Destination DSCP value rewriting definition number
Specify a new priority for <count> with a decimal value.
If any definition with the same definition number exists, it will be inserted before the
existing one.
Range
0 to 511 XG0224 / XG0448
0 to 63 XG2600
Configuration mode (admin class)
Change the priority of DSCP value rewriting conditions.
"resource filter distribution"
"ether qos aclmap",
aclmap", "lan ip filter",
196
Chapter 5 Command Reference
command and change
"vlan macfilter", "vlan ip6filter",
"lan ip dscp", "lan ip6 filter",
Model
LAN Information Settings
"lan