Ether Qos Aclmap Move - Fujitsu XG Series User Manual

XG Series User's Guide
Default
5.1.6.2

ether qos aclmap move

Function
Available Model
Syntax
Options
Use Mode
Explanation
Default
- For ACL not to set TCP, UDP, or ICMP
1
You can expand the upper limit to use
resource distribution.
Note 4.
Up to 700 commands can be set for the entire device, including the definitions which refer
to ACL such as "ether macfilter",
"vlan qos aclmap", "vlan ip6qos
ip6 dscp" and "serverinfo filter" commands.
Note 5.
When the port type of the Ethernet port is a link aggregation, set it only to the anchor port
where the link aggregation is composed.
It is assumed that this option has not been set.
Change the QoS conversion priority of the Ethernet port.
XG0224 / XG0448 / XG2600
ether <number> qos aclmap move <count> <new_count>
<number>
• ether port number
Set a port number to use with a decimal value.
When setting multiple port numbers, separate them with commas (,).
When setting sequential numbers, separate them with hyphens (-). (Example: "1-8")
<count>
• Source priority
Set the source priority with a decimal value.
<new_count>
• Destination priority
Set the destination priority with a decimal value.
Range
0 to 511 XG0224 / XG0448
0 to 63 XG2600
Configuration mode (admin class)
Change the priority of QoS definition for each Ethernet port.
If the current priority is set as <count>, change the priority of this definition to
<new_count>.
When the definition is changed, the priority is renumbered.
N/A due to an edit command.
"resource filter distribution"
"ether qos aclmap",
aclmap", "lan ip filter",
142
Chapter 5 Command Reference
command and change
"vlan macfilter", "vlan ip6filter",
"lan ip dscp", "lan ip6 filter",
Model
Port Information Settings
"lan