Fujitsu XG Series User Manual page 549

XG Series User's Guide
When a SFP+ Card is installed.
# show system status
Current-time
Startup-time
restart_cause
machine_state
power0_state
fan0_state
inspiration_state
phy_state
slot1_state
inspiration_temp
phy_temp
slot1_temp
Slot Information
slot1
1) Current time
Present date and time.
2) Startup time
Date and time when the system started up.
3) restart_cause
Cause for the system startup.
The following system startup causes are displayed:
power on
reset
reset switch
system down
4) machine_state
State of the device
RUNNING
5) power0_state
State of the power unit.
NORMAL
NO_PRESENT : The power unit is not installed.
FAIL
UNKNOWN
6) fan0_state
State of the fan 0.
NORMAL
ABNORMAL
UNKNOWN
7) inspiration_state
State of environment temperature monitor.
phy_state
State of temperature monitor around PHY.
slot1_state
State of Expansion Card temperature monitor (SLOT1).
: Wed Dec 10 06:03:04 2008
: Wed Dec 10 06:02:19 2008
: reset
: RUNNING
: NORMAL
: NORMAL
: NORMAL
: NORMAL
: NORMAL
: 25 C
: 39 C
: 39 C
: SJ10GSFPZ
: The power has been turned on.
: The reset command has been issued.
: The [RESET] switch has been pressed.
: System-down has occurred.
: The device is active.
: The power unit works normally.
: The power unit has been turned off.
: The power unit is invalid state.
: The fan works normally.
: The fan has been abnormal.
: The fan is invalid state.
549
Chapter 6 Managing the Device
---(1)
---(2)
---(3)
---(4)
---(5)
---(6)
---(7)
---(8)
---(9)
Verifying the Device Operations