Table of Contents
Advertisement
XG Series User's Guide
The following commands spend 1 action for each.
If same <tos_value> is used, the commands use 1 action for them.
If same <dscp_value> is used, the commands use 1 action for them.
If same <queue_value> is used, the commands use 1 action for them.
- ether <number> qos aclmap <count> tos <tos_value> <acl>
- ether <number >qos aclmap <count> dscp <dscp_value> <acl>
- ether <number> qos aclmap <count> queue <queue_value> <acl>
- vlan <vid> qos aclmap <count> tos <tos_value> <acl>
- vlan <vid> qos aclmap <count> dscp <dscp_value> <acl>
- vlan <vid> qos aclmap <count> queue <queue_value> <acl>
- lan <number> ip dscp <count> acl <acl_count> <dscp_value>
The following commands spend 1 action for each.
If same <vid> is used, the commands use 1 action for them.
- vlan <vid> protocol <count> ether
- vlan <vid> protocol <count> llc
Note 5.
When the port type of the Ethernet port is a link aggregation, the same setting is needed
in all the member ports where the link aggregation is composed.
[XG0224/XG0448]
Note 3.
This command is unavailable if the allowable upper limit for the device is exceeded.
The allowable upper limits are as follows.
• Upper limit based on "commands"
128 commands for the entire device.
Up to 128 commands can be set for the entire device, including the
"vlan macfilter"
and
"lan ip filter"
The priority for each command is as follows.
1)
"ether macfilter"
command
A smaller Ethernet port number has a higher priority among Ethernet ports.
2)
"vlan macfilter"
command
A smaller VLAN ID has a higher priority among VLANs.
3)
"lan ip filter"
command
A smaller lan definition number has a higher priority among lans.
If up to 128 of
"ether macfilter"
subsequent
"vlan macfilter"
• Upper limit based on rule
128 rules for the entire device.
For the
"ether
macfilter",
rules to be used varies depending on the contents of the specified acl as shown below.
The number of rules for each ACL is as follows.
- For ACL to set TCP or UDP
Result of multiplication between the number of source ports and the number of
destination ports for TCP or UDP
- For ACL to set ICMP
Result of multiplication between the number of ICMP TYPEs and the number of
ICMP CODEs for ICMP
- For ACL not to set TCP, UDP, or ICMP
1
commands.
commands have been defined for port ether1, the
and
"lan ip filter"
command will be no longer applied.
"vlan macfilter"
and
"lan ip filter"
135
Chapter 5 Command Reference
"ether
macfilter",
commands, the number of
Port Information Settings
Advertisement
Table of Contents
