Fujitsu XG Series User Manual page 156

XG Series User's Guide
Use Mode
Explanation
Caution
<ether-type>
Specify the Ethertype or LLC value if the protocol is defined by the user.
• Specify the Ethertype value for Ethernet II format or IEEE 802.3 SNAP format frames,
or specify an LLC value (DSAP or SSAP) for IEEE 802.3 LLC format frames, using a 4-
digit hexadecimal value (from 0000 to ffff).
Setting example)
ipx : ethertype=8137,8138
appletalk : ethertype=809b,80f3
• If EthernetII format was specified, the EtherType value = 0000 to 05ff setting is
disabled.
Configuration mode (admin class)
Set the protocol VLAN conditions using this command.
The protocol can be set by one of the following two methods.
• Selecting a system-defined protocol (ipv4/ipv6/fna).
• Directly specifying a protocol type in the user definition.
• No protocol VLANs can be set for the default VLAN (VLAN ID=1).
• Up to 8 definitions can be given to set the user-defined protocol conditions for the
entire device.
• Both the system-defined <protocol-type> definition and the user definition cannot be
specified in the same VLAN all together.
• The same protocol definition as the system-defined <protocol-type> definition can be
used as the user definition.
However, if these definitions compete against each other on the same port, only the
VLAN with a smaller identification number will be enabled. For example, the following
can be set:
ether 1 vlan untag 10
ether 2 vlan untag 20
vlan 10 protocol ipv4
vlan 20 protocol 0 ethertype 0800
However, if "ether 1 vlan untag 10,20" is set for the Ethernet port, the ether1 port is
included in VLAN10 but not included in VLAN20.
• The same protocol definition can be used for multiple different VLANs.
However, if those VLANs compete against each other on the same port, only the VLAN
with a smaller identification number will be enabled. For example, the following can be
set:
ether 1 vlan untag 10
ether 2 vlan untag 20
vlan 10 protocol ipv4
vlan 20 protocol ipv4
However, if "ether 1 vlan untag 10,20" is set for the Ethernet port, the ether1 port is
included in VLAN10 but not included in VLAN20.
• If the protocol type differs, multiple protocol VLANs can be set on the same port. For
example, the following can be set:
ether 1 vlan untag 10,20
vlan 10 protocol ipv4
vlan 20 protocol ipv6
• If "delete vlan <vid> protocol" is set, all VLAN protocol conditions are deleted, but the
VLAN itself is not deleted. (The VLAN can be deleted by the "ether vlan" command.)
156
Chapter 5 Command Reference
VLAN Information Settings