Table of Contents
Advertisement
XG Series User's Guide
for the device as below.
XG2600(config)# ether 1 vlan untag 1
XG2600(config)# lan 0 vlan 1
XG2600(config)# lan 0 ip 192.168.1.1/24 3
XG2600(config)# commit
XG2600(config)# save
A VT100, VT200, or xterm can be used as a terminal.
2.1.2
Command Modes and Mode Switching
The following table shows a hierarchy of command modes and mode switching.
2.1.2.1 Command Operation Procedure
The flow of system operation via command execution is as follows:
1) Login to the device.
2) Run an operation command to manage system operations.
3) Run a configure command to move to configuration mode.
4) Run a configuration command to set candidate configuration (candidate-config).
5) Run a commit command to apply the candidate configuration as a running configuration (running-config).
6) Run a save command to save the candidate configuration as a startup configuration (startup-config).
7) Run an exit or similar command to return to operation mode.
8) Repeat steps 2) through 7)
9) Run an exit command to log out.
" Login to the device"
Reference
Login
user name
user
admin
(pg.40),
"2.1.2.2 Executable commands" (pg.42)
Operation mode
admin / su
User
class
exit
exit / !
exit
Operation command
Running configuration
(running-config)
configure
Admin
class
exit / ! / end / quit
commit
load
reset / Reconnect power
39
Chapter 2 Using the CLI
Configuration mode
Admin
class
Operation command
Configuration command
Candidate configuration
(candidate-config)
save
load
Startup configuration
(startup-config)
Overview of the CLI
Advertisement
Table of Contents
