Denon AVR-4520CI Owner's Manual page 38

Preparation (Continued)
5
Select "Start" and then press
ENTER
.
Audyssey Setup
Open the front panel door and connect the calibration
microphone to the SETUP MIC input.
Back
6
ENTER
Select "Next" and then press
The subwoofer volume setting screen is displayed.
Audyssey Setup
Make sure your subwoofer is plugged in and turned on. If your
subwoofer has a volume control on it, please set it at 50%...
POWER VOLUME
ON
OFF MIN MAX
Back
DVD
Detection & Measurement (Main)
This step automatically checks the speaker configuration and speaker
size, and calculates the channel level, distance, and crossover
frequency.
It also corrects distortion in the listening area.
7
Select "Begin Test" and then press
The volume level for the subwoofer is measured.
• If the volume level for the subwoofer is not appropriate, an error
message is displayed. See "Subwoofer level error message and
how to adjust" (vpage 39) and adjust the volume level for the
subwoofer.
• Measurement requires several minutes.
• To stop measuring, select "Cancel" and then press
8
The detected speakers are displayed.
Next
• The illustration below shows an example of when the front
. speakers, center speaker, subwoofer, surround and surround back
speakers have been detected.
Speaker Detection
Front
Center
Subwoofer
Surround
Surr. Back
Next
NOTE
If a connected speaker is not displayed, the speaker may not be
connected correctly. Check the speaker connection.
9
Select "Next" and then press
ENTER
.
ENTER
.
Audyssey Setup
:Yes
:Yes
:2spkrs
:Yes
:2spkrs
Repeat Last Test Next
ENTER .
35
Set up speakers (Audyssey ® Setup)
NOTE
If "Caution!" is displayed on TV screen:
Go to "Error messages" (vpage 38). Check any related items,
and perform the necessary procedures.
If the problem is resolved, return and restart "Audyssey ® Setup".
Going back to the previous screen
ENTER
Select "Back" and then press .
When measuring has stopped
BACK
q Press to display the popup screen.
o ENTER
w Press to select "Yes", and then press
Setting up the speakers again
Repeat the operation from step 4.
.
v See overleaf