Denon AVR-4520CI Owner's Manual page 30

Connecting an HD Radio receiver
• By connecting a HD Radio antenna to this unit, you can receive HD Radio programs.
• HD Radio broadcasting currently is available in the United States and select other countries.
• After connecting the antenna and receiving a broadcast signal
stations"), fix the antenna with tape in a position where the noise level becomes minimal.
n AM loop antenna assembly
1
Put the stand section through the bottom of the
loop antenna from the rear and bend it forward.
2
Insert the projecting part into the square hole in
the stand.
n Using the AM loop antenna
Suspending on a wall
Suspend directly on a wall without assembling.
Nail, tack, etc.
NOTE
• Do not connect two FM antennas simultaneously.
• Even if an external AM antenna is used, do not disconnect the AM loop antenna.
• Make sure the AM loop antenna lead terminals do not touch metal parts of the panel.
• If the signal has noise interference, connect the ground terminal (GND) to reduce noise.
• If you are unable to receive a good broadcast signal, we recommend installing an outdoor antenna. For
details, inquire at the retail store where you purchased the unit.
DVD
(vpage 51 "Listening to HD Radio
Stand
Square
Loop
hole
antenna
Projecting
part
Standing alone
Use the procedure shown above to assemble.
AM loop antenna (for HD Radio
broadcasting, supplied)
• To prevent interference, install at least 3.3
ft/1 m away from the antenna connected
to the this unit's other AM tuner terminal.
q
Black
Ground
27
Connecting an HDMI-incompatible device
Direction of broadcasting station
FM outdoor
antenna
w e
75 Ω coaxial
cable
FM indoor antenna
White
(for HD Radio
broadcasting, supplied)
AM outdoor
antenna