Set Up Speakers - Denon AVR-4520CI Owner's Manual

Set up speakers

This section describes detailed settings for Audyssey ® Setup.
First install and connect the speakers to this unit.
Before Audyssey ® Setup measurement, the settings shown below can be made.
• Changing the amplifier assignment (Amp Assign)
The signal output from the SURROUND BACK, FRONT HEIGHT and FRONT WIDE speaker terminal of this unit can be switched to match your speaker environment
• Setting the channels to be used (Channel Select)
If channels that are not to be used are set in advance, measurement for the set channels is skipped, and measuring time can be reduced. You can also change the number of surround back speakers
"Set up "Channel Select"").
1
Set up the zone mode
ZONE SELECT
Press to switch the zone mode.
J
The indicator lights.
Press ZONE SELECT
NOTE
When using a remote control with preset codes registered
AVR
(vpage 160), press to set the remote control to the AVR-
operation mode before operation.
DVD
2
Connect the setup microphone.
When the setup microphone is
connected, the following screen is
displayed.
Audyssey Setup
Your AV receiver can automatically measure the acoustics of
your room then optimize your speakers using the included
microphone.
Set the following items
if necessary.
Amp Assign
Channel Select
Check Results
Restore...
Start
99
around items indicate the settings.
(vpage 99 "Set up "Amp Assign"").
3
Set up "Amp Assign"
ui
Use to select "Amp Assign", and then press
ENTER .
Audyssey Setup
Your AV receiver can automatically measure the acoustics of
your room then optimize your speakers using the included
microphone.
Set the following items
if necessary.
Amp Assign
Channel Select
Check Results
Restore...
Start
Amp Assign [1/2]
Assign Mode 7.1ch + ZONE2
Main Speakers S.Back/F.Height
Front Speaker
Center Speaker
Surround Speaker
Surr. Back Auto Spkr
Front Height Auto Spkr
Front Wide Not Used
ZONE2 Speaker
ZONE3 Pre-amp out ZONE2: ZONE3:
Selects how to use the internal amplifiers
4
Select "Assign Mode", and then press
(vpage 101
ENTER .
v See overleaf