Denon AVR-4520CI Owner's Manual page 104

13
Set up "Channel Select"
Use ui to select "Channel Select", and then press
ENTER
.
Audyssey Setup
Your AV receiver can automatically measure the acoustics of
your room then optimize your speakers using the included
microphone.
Set the following items
if necessary.
Amp Assign
Channel Select
Check Results
Restore...
Start
Channel Select
Subwoofer Measure(1spkr)
Surround Back Measure(2spkrs)
Front Height Measure
DVD
14
Use ui to select a channel, and then press
Front / Subwoofer / Surround Back / Front Height / Front Wide
15
o p
Use to select a front speaker, and then press
ENTER
.
A
Select this to use front speaker A.
B
Select this to use front speaker B.
A+B
Select this to use front speakers A and B simultaneously.
16
Use o p to set whether or not a subwoofer channel is
ENTER
measured, and then press
Measure Set for measuring two subwoofers (Audyssey Sub EQ
(2 spkrs) HT™).
Measure
Set for measuring a subwoofer.
(1 spkr)
Skip Set for no measuring of a subwoofer.
17
o p
Use to set whether or not a surround back
channel is measured, and then press
Measure
Set for measuring two surround back speakers.
(2 spkrs)
Measure
Set for measuring a surround back speaker.
(1 spkr)
Skip
Set for no measuring of a surround back speaker.
18
o p
Use to set whether or not a front height channel
is measured, and then press ENTER
Measure Set to measure the front height speakers.
Skip Set when you do not want to measure the front height
speakers.
101
19
ENTER . Use o p to set whether or not a front wide channel is
measured, and then press
Measure Set to measure the front wide speakers.
Skip Set when you do not want to measure the front wide
speakers.
20
Press o or
Proceed to page 35
NOTE
After performing Audyssey ® Setup, do not change the speaker
connections or subwoofer volume. In event of a change, perform
.
Audyssey ® Setup again.
ENTER .
.
Set up speakers
ENTER
.
BACK .
Preparation
step 5.