Replacing The Side Cover; Connecting External Options - IBM IntelliStation M Pro User Manual

Replacing the side cover

To replace the side cover, complete the following steps:
1. Make sure that all cables, adapters, and other components are installed and
2. Install the side cover by placing it into position on the computer. Make sure that
3. Reconnect the external cables and power cords to the computer; then, connect
4. Turn on the attached devices; then, turn on the computer.

Connecting external options

You can connect a number of optional external devices to the connectors on the
rear and front of the computer.
To connect an external device, complete the following steps:
1. Read the safety information that begins on page vii, the Installations guidelines
2. Turn off the computer and all attached devices (see "Turning off the computer"
3. Follow the instructions that come with the device to prepare it for installation
If you are attaching a SCSI device, see "Ultra320 SCSI connector" on page 71 for
SCSI ID and cabling information.
seated correctly and that you have removed all work tools or parts from inside
the computer.
the lip on the bottom of the cover rests on the ledge on the bottom of the
chassis. Slide the side cover forward to lock the side cover.
the power cords to electrical outlets.
on page 35, and the documentation that comes with the device.
on page 19).
and to connect it to the computer.
Chapter 4. Installing options
67