Checking Calibration Status; Using A Densitometer; Setting Up The Densitometer; To Connect The X-Rite Dtp32 To The Computer - Xerox 2006NPC - DocuColor Color Laser User Manual
Docucolor 2006 user guide
Hide thumbs
Also See for 2006NPC - DocuColor Color Laser:
- Manual (27 pages) ,
- Maintenance manual (19 pages) ,
- Use manual (9 pages)
Table of Contents
Advertisement
20. Using ColorWise Pro Tools
Checking Calibration Status
You can check whether the Fiery is calibrated, which calibration set and
output profile were used, and when the copier was last calibrated:
•
Print a Configuration page or Test Page from the Control Panel.
•
When you select a calibration set in Calibrator, the last calibration and
the user who performed it are displayed.
Using a Densitometer
ColorWise Pro Tools are designed to work with the X-Rite DTP32 reflection
densitometer where color measurements are entered automatically.
Setting up the Densitometer
Before you calibrate the Fiery, you need to connect, configure, and calibrate
the densitometer to prepare for measuring the printed patches. For additional
information about setting up and using the densitometer see the
documentation included with it.
To Connect the X-Rite DTP32 to the Computer
1.
Turn off the computer.
2.
Plug the square end of the interface cable (looks like a modular phone
plug) into the I/O port on the side of the X-Rite DTP32.
3.
Attach the connector to the computer.
For a Windows computer, insert the 8-pin mini-DIN end of the interface
cable into the 9-pin DB9 Connector cable adapter. Insert the 9-pin end
into the COM1 or COM2 port on the computer and tighten the screws. If
the available port on your computer is 25-pin, you must use the 8-pin to
25-pin adapter.
For a Mac OS computer, connect the 8-pin mini-DIN plug directly into
the serial port of the computer.
For Macintosh computers with a USB port, you need an adapter to connect the
DTP32 to your computer. See the X-Rite, Inc. web site at
information on supported adapters.
4.
Use the AC adapter to provide power.
Plug the small connector on the adapter cable into the side of the X-Rite
DTP32 and plug the adapter into a wall outlet.
5.
Turn on the computer
6.
Calibrate the densitometer.
7.
Use ColorWise Pro Tools to calibrate the Fiery.
20–4
www.x-rite.com
for
Xerox DocuColor 2006
Advertisement
Table of Contents
