Table of Contents
Advertisement
MegaRAID Storage Manager Software Customization
You can customize your logo and the splash screen by editing the msm.properties file present
in the <installation-directory/MegaRAID Storage Manager> folder.
The msm.properties file has no values for the following keys:
•
CHANNELLOGO=
•
CHANNELSPLASHSCREEN=
No default values are assigned for these keys, therefore the MegaRAID Storage Manager
software uses the default LSI logo and the splash screen.
To customize the logo and the splash screen, enter the logo and the splash screen file name
against these entries.
To enter the file names, follow these steps:
1. Open the file msm.properties in the <installation-directory/MegaRAID Storage
Manager> folder.
2. Enter the value for the logo file against the key CHANNELLOGO.
3. Enter the value for the splash screen file against the key CHANNELSPLASHSCREEN.
4. Save the file.
5. Place these two images in the <installation-directory/MegaRAID Storage
Manager> folder.
6. Start the application.
Following are some important points that you need to keep in mind:
•
File names for both entries should not have any spaces. For example, the valid file name
would be: logo_test_1.png or LogoTest1.png or TEST_SPLASH_FILE.jpg.
•
The logo image dimensions should not exceed 160 * 85 (width * height).
•
The splash screen image dimensions should not exceed 390 * 260 (width * height).
After making these changes, you can view the changes with the new splash screen and the logo
in the MegaRAID Storage Manager software when you log in to the MegaRAID Storage Manager
software.
Installation
DB09-000202-05 37857-02
Rev. F - May 2011
Manager Framework service.
To stop the Monitor service, run svcadm disable -t MSMMonitor.
To start the Framework service, run svcadm enable MSMFramework.
When the service is in maintenance state, run the svcadm clear MSMFramework
command and svcadm clear MSMMonitor command.
To start the monitor service, run svcadm enable MSMMonitor command.
To check the status of the MegaRAID Storage Manager services, run the command
svcs -a | grep -i msm.
Copyright © 2011 by LSI Corporation. All rights reserved.
Page 9
Advertisement
Table of Contents
