Table of Contents
Advertisement
Note:
4. Click Suggest Security Key to have the system create a security key or you can enter a new
security key.
5. Enter the new security key again to confirm, as shown in the following figure.
Note:
The security key is case-sensitive. It must be between 8 and 32 characters and contain at
least one number, one lowercase letter, one uppercase letter, and one non-alphanumeric
character (e.g. < > @ +). The space character is not permitted.
Note:
The following figure shows the security key entered and confirmed on this window.
Figure 143 Enable Drive Security - Security Key
6. (Optional) Select the Pause for password at boot time check box.
If you choose this option, you have to enter the password whenever you boot the server.
7. (Optional) Select the Enforce strong password security check box.
If you choose this option, make sure the password is between eight and thirty-two characters
and contain at least one number, one lowercase letter, one uppercase letter, and one non-
Page 146
Using the MegaRAID Advanced Software
DB09-000202-05 37857-02
Rev. F - May 2011
If you create more than one security key, make sure that you change the security
key identifier. Otherwise, you cannot differentiate between the security keys.
If you forget the security key, you will lose access to your data. Be sure to
record your security key information. You might need to enter the security key to
perform certain operations.
Non-US keyboard users must be careful not to enter DBCS characters in the security
key field. Firmware works with the ASCII character set only.
Copyright © 2011 by LSI Corporation. All rights reserved.
Advertisement
Table of Contents
