Table of Contents
Advertisement
Figure 136 Change Security Settings
When you select the Change current security settings option, you get a different EKM key for
the controller.
Based on the application's response two scenarios occur - the first scenario is, when EKM server
is present, and the second scenario is, when EKM server is not present.
Scenario # 1- EKM server is present
If EKM server is present, you will get a confirmation message indicating that the drive security is
enabled on the controller as shown in the following figure.
Figure 137 EKMS server is present
Scenario # 2 - EKM server is not present
When EKM server is not present, you have to restart the system, and during re-boot the boot
agent generates the security keys.
When you restart the system, the system restart message appears, as shown in the following
figure.
Figure 138 System Restart
Page 142
Using the MegaRAID Advanced Software
DB09-000202-05 37857-02
Rev. F - May 2011
Copyright © 2011 by LSI Corporation. All rights reserved.
Advertisement
Table of Contents
