Table of Contents
Advertisement
If you select the Client installation for a computer used to monitor servers, and if there are no
available servers with a registered framework on the local subnet (that is, servers with a complete
installation of MegaRAID Storage Manager software), the server screen appears. The server
screen does not list any servers. You can use this screen to manage systems remotely.
To install the software using interactive mode, run the command ./install.sh from the installation
disk.
To install the product in a non-interactive or silent mode, use the command ./install.sh
[-options] [ -ru popup] from the installation disk. The installation options are:
•
Complete installation
•
Client Component Only
•
StandAlone
•
Local mode
The -ru popup command removes the pop-up from the installation list.
You also can run a non-interactive installation using the RunRPM.sh command.
The installer offers the following setup options:
•
Complete – This option installs all the features of the product.
•
Client Components Only – The storelib feature of the product is not installed in this type of
installation. As a result, the resident system can only administer and configure all of the
servers in the subnet but it cannot serve as a server.
•
StandAlone – Only the networking feature is not installed in this case, so the resident system
is not a part of the network. This implies that the system cannot browse any other MegaRAID
Storage Manager servers in the subnet, and the MegaRAID Storage Manager servers cannot
recognize it as a server.
•
Local mode - This option enables you to view only the workstation that has the MegaRAID
Storage Manager software installed. You will not be able to discover other remote servers and
other remote servers will also not be able to connect to your workstation. In a local mode
installation, you will be using the loopback address instead of the IP address.
This installation helps you select any of the setup types, but if you run RunRPM.sh, it installs the
complete feature.
Uninstalling MegaRAID Storage Manager Software on Linux
To uninstall the MegaRAID Storage Manager software on a system running Linux, follow these
steps:
1. Go to /usr/local/MegaRAID Storage Manager.
2. Run ./uninstaller.sh.
This procedure uninstalls the MegaRAID Storage Manager software.
Executing a CIM Plug-in on Red Hat Enterprise Linux 5
To execute a Common Information Model (CIM) plug-in on Red Hat Enterprise Linux 5, you must
create the following symbolic links:
Page 6
Installation
DB09-000202-05 37857-02
Rev. F - May 2011
Copyright © 2011 by LSI Corporation. All rights reserved.
Advertisement
Table of Contents
