Table of Contents
Advertisement
1. cd /usr/lib on RHEL 5
2. Search for libcrypto, libssl, and libsysfs libraries as follows:
ls -lrt libcrypto*, ls -lrt libssl*, ls -lrt libsysfs*
3. If the files libcrypto.so.4, libssl.so.4, and libsysfs.so.1 are missing, manually create
sym links as follows:
ln -s libcrypto.so libcrypto.so.4
ln -s libssl.so libssl.so.4
ln -s libsysfs.so libsysfs.so.1
See
Installing and Supporting MegaRAID Storage Manager Software on VMware
information about CIM.
Note:
Installing and Supporting MegaRAID Storage Manager Software on Solaris
10U5, U6, U7, and U8 (Both x86 and x64)
This section documents the installation of MegaRAID Storage Manager software on the Solaris
U5, U6, U7, and U8 x86 and x64 operating systems, and Solaris SPARC. This section also
includes the following topics:
•
Installing MegaRAID Storage Manager Software for Solaris 10 x86
•
Uninstalling MegaRAID Storage Manager Software for Solaris 10 x86
•
Installing MegaRAID Storage Manager Software for Solaris 10 SPARC
•
Uninstalling MegaRAID Storage Manager Software for Solaris 10 SPARC
Installing MegaRAID Storage Manager Software for Solaris 10 x86
Follow these steps to install the MegaRAID Storage Manager software on a system running
Solaris 10 x86:
1. Copy the MegaRaidStorageManager-SOLX86-...tar.gz file to a temporary folder.
2. Untar the MegaRaidStorageManager-SOLX86-...tar.gz file using the following command:
tar -zxvf MegaRaidStorageManager-SOLX86-...tar.gz
This step creates a new disk directory.
3. Go to the new disk directory and find and read the readme.txt file.
4. Enter the Bash shell.
5. Run the command ./install.sh present in the disk directory.
Installation
DB09-000202-05 37857-02
Rev. F - May 2011
If the '.so' files are not present in the /usr/lib directory, create a link with the
existing version of the library.
For example, if libcrypto.so.6 is present and libcrypto.so is not, create the link
as follows:
ln -s libcrypto.so.6 libcrypto.so.4
On a 64-bit operating system, the system libraries are present in the /usr/lib64
directory by default. However, for supporting CIM Plug-in, make sure that the
libraries are also present in /usr/lib by installing the appropriate RPMs.
Copyright © 2011 by LSI Corporation. All rights reserved.
for more
Page 7
Advertisement
Table of Contents
