Table of Contents
Advertisement
2. Choose any one of the following options to arrive at the Drive Security Choose Mode wizard.
•
Select Go To> >Controller>>Enable Drive Security in the main navigation bar in the top
portion of the MegaRAID Storage Manager window.
•
Right-click the controller icon, and click Enable Drive Security menu.
The Drive Security Choose Mode wizard appears, as shown in the following figure.
Figure 128 Drive Security Choose Mode
3. Select External Key management (EKM).
4. Click OK.
After you click OK, two scenarios occur based on the availability of EKMS.
Scenario # 1 - EKM is enabled
When EKM is enabled, you can see the confirmation message as shown in the following figure.
The message displayed ensures that security is enabled on the controller using EKMS.
Figure 129 Confirm External Key Management Mode Enabled
Note:
Scenario # 2 - EKM is selected, and EKMS is not present
Page 138
Using the MegaRAID Advanced Software
DB09-000202-05 37857-02
Rev. F - May 2011
On the right hand side frame of the controller properties, in Drive Security
Properties, you can see the key management mode is EKM.
Copyright © 2011 by LSI Corporation. All rights reserved.
Advertisement
Table of Contents
