Removing Email Addresses Of Recipients Of Alert Notifications; Saving Backup Configurations; Loading Backup Configurations - LSI X79 Extreme11 User Manual

2. Click an email address in the Recipient email addresses field.
3. Click Test.
4. Confirm whether the test message was sent to the email address.
A pop-up message indicates if the test message sent to the email address was successful. If
the MegaRAID Storage Manager software cannot send an email message to the email
address, an error message appears.

Removing Email Addresses of Recipients of Alert Notifications

Use the Email tab in the Configure Alerts window to remove email addresses of the recipients of
alert notifications.
1. Click the Email tab on the Configure Alerts window.
The Email section of the window appears, as shown in the previous figure.
2. Click an email address in the Recipient email addresses field.
The Remove button, which was grayed out, is now active.
3. Click Remove. The email address is deleted from the list.

Saving Backup Configurations

You can save an .xml backup file of the entire alert configuration. This includes all the settings
on the three tabs (Alert Settings, Mail Server, and Email).
1. On the Configure Alerts window, click the Alert Setting tab, Mail Server tab, or the Email
tab.
2. Click Save Backup. The drive directory appears.
3. Enter a filename with an .xml extension for the backup configuration (in the format
filename.xml).
4. Click Save. The drive directory disappears.
5. Click OK. The backup configuration is saved and the Configure Alerts window closes.

Loading Backup Configurations

You can load all of the values from a previously saved backup into the Configure Alert window
(all tabs) to edit or save these values as the current alert notification configuration.
Note:
1. On the Configure Alerts window, click the Alert Setting tab, Mail Server tab, or Email tab.
2. Click Load Backup.
You are prompted to confirm your choice. The drive directory appears from which you can
select a backup configuration to load.
3. Select the backup configuration file (it should be in .xml format).
4. Click Open. The drive directory disappears.
5. Click OK. The backup configuration is saved and the Configure Alerts window closes.
Page 78 Monitoring Controllers and Its Attached Devices
DB09-000202-05 37857-02 Rev. F - May 2011
If you choose to load a backup configuration and the Configure Alerts window
currently contains changes that have not yet been saved as the current alert
notification configuration, the changes will be lost. You are prompted to confirm your
choice.
Copyright © 2011 by LSI Corporation. All rights reserved.