Table of Contents
Advertisement
Figure 145 Confirm Create Security Key Screen
10. Select the I recorded the security settings for future reference check box and then click
Yes to confirm that you want to enable drive security on this controller and have recorded the
security settings for future reference.
The MegaRAID Storage Manager software enables drive security and returns you to the main
menu window.
Change Security Settings - LKM
Perform the following steps to change the encryption settings for the security key identifier,
security key, and password.
1. Select the Physical View tab in the left panel of the MegaRAID Storage Manager main menu
screen, and click a controller icon.
2. Select Go To -> Controller -> Change Drive Security.
The Change Security Settings – Introduction screen appears. This screen lists the actions you
can perform, which include editing the security key identifier, security key, and the password.
3. Click Next.
The Change Security Settings - Security Key ID screen appears.
4. Keep the existing security key identifier or enter a new security key identifier.
Important:
5. Click Next.
Page 148
Using the MegaRAID Advanced Software
DB09-000202-05 37857-02
Rev. F - May 2011
If you change the security key, LSI highly recommends that you change the security
key identifier. Otherwise, you cannot differentiate between the security keys.
Copyright © 2011 by LSI Corporation. All rights reserved.
Advertisement
Table of Contents
