Table of Contents
Advertisement
# svcadm enable svc:/application/management/sma:default
Note:
Configuring SNMP Traps
To receive SNMP traps, perform the following steps:
1. Stop the LSI SAS SNMP Agent by using the following command:
#/etc/init.d/lsi_mrdsnmpd stop
2. Edit the /etc/lsi_mrdsnmp/sas/sas_TrapDestination.conf file and add the IP address as
shown in the following excerpt:
#################################################
# Agent Service needs the IP addresses to sent trap
# The trap destination may be specified in this file # or using snmpd.conf
file. Following indicators can # be set on "TrapDestInd" to instruct the
agent to
# pick the IPs as the destination.
# 1 - IPs only from snmpd.conf
# 2 - IPs from this file only
# 3 - IPs from both the files
#################################################
TrapDestInd 2
#############Trap Destination IP##################
127.0.0.1
172.28.157.149 public
#################################################
3. Start the LSI SAS SNMP Agent by entering the following command:
#/etc/init.d/lsi_mrdsnmpd start
Uninstalling the SNMP Package
The uninstall.sh script is located under the /etc/lsi_mrdsnmp/sas directory. Use the following
command to uninstall the package:
# cd /etc/lsi_mrdsnmp/sas
# ./uninstall.sh
Installing a SNMP Agent on Windows
This section explains how to install and configure the SAS SNMP Agent for the Windows operating
system.
Installing SNMP Agent
Perform the following steps to install the SNMP Agent:
1. Run setup.exe from DISK1.
2. Use the SNMP Manager to retrieve the SAS data (it is assumed that you have compiled LSI-
AdapterSAS.mib file already).
Installation
DB09-000202-05 37857-02
Rev. F - May 2011
Refer to the command man snmpd.conf for more information about configuring the
snmpd.conf file.
public
Copyright © 2011 by LSI Corporation. All rights reserved.
Page 19
Advertisement
Table of Contents
