Table of Contents
Advertisement
To choose automatic battery learn cycles, enable automatic learn cycles. To choose manual
battery learn cycles, disable automatic learn cycles.
If you enable automatic learn cycles, you can delay the start of the learn cycles for up to 168
hours (7 days). If you disable automatic learn cycles, you can start the learn cycles manually, and
you can choose to receive a reminder to start a manual learn cycle.
Setting Learn Cycle Properties
To set the learn cycle properties, perform the following steps:
1. Click the Physical tab to open the Physical view.
2. Select the BBU icon in the left panel.
3. Select Go To->BBU->Set Learn Cycle Properties. The Set Learn Cycle Properties window
appears, as shown in the following figure.
Figure 68
4. Select one of the two automatic learn cycles:
•
Select the Enable radio button to enable an automatic learn cycle.
•
Select the Disable radio button to disable an automatic learn cycle.
5. You can delay the start of the next learn cycle up to 7 days (168 hours) by specifying the
hours in the Delay scheduled learn cycle by field.
6. Select the Remind me when to start a learn cycle check box to receive a reminder to start
a manual learn cycle.
Note:
Page 86
Monitoring Controllers and Its Attached Devices
DB09-000202-05 37857-02
Rev. F - May 2011
Set Learn Cycle Properties
After selecting Disable, if you select Enable, the controller firmware resets the
battery module properties to initiate an immediate battery learn cycle. The Next
Learn cycle field (in
Figure 66
relearn is completed. Once the relearning cycle is completed, the value in the Next
Learn cycle field will display the new date and the time of the next battery learning
cycle.
Copyright © 2011 by LSI Corporation. All rights reserved.
or
Figure
67) will not be updated until the battery
Advertisement
Table of Contents
