Turning Remote Diagnosis On/Off - Kyocera KM-2030 Instruction Handbook Manual

Section 6 Various Settings and Registration in this Fax

Turning Remote Diagnosis ON/OFF

Especially if trouble occurs in this fax in which it is necessary to call
for service, it is possible for our service center computer to access
the fax directly over the telephone line and check its status and other
information about the trouble.
* To use Remote Diagnosis, it is necessary to enter into a contract
with an authorized service center in advance and also to register a
predetermined Remote Test ID in advance.
(Refer to "Registering the Remote test ID".)
For further information, contact your service representative, an
authorized service center or the place of purchase.
* If you want to cancel the procedure part way through, press the
Reset key. The operation panel will return to the initial mode settings.
Set Document
Set original
1. Raise the cover plate and press the Configure key.
(Inch)
Set Fax:
End
Line Type
TTI
Set fax:
End
TTI
Print report
2. Use the cursor up or the cursor down key to select "Remote Diag."
["Remote diagn."].
Set Fax:
2 in 1 RX
Management
Remote Diag.
Set fax:
2-up RX
Management
Remote diagn. :Off
3. Press the Enter key.
Remote Diag.:
*On
Off
Remote diagn.:
On
*Off
6-14
JUL-08-2001 12:00
(Inch)
08-JUL-2001 12:00
(Metric)
(Metric)
(Inch)
:Tone Dial
:Outside P.
(Metric)
:Outside p.
P P
:Off
(Inch)
:Off
:On
:Off
(Metric)
:Off
(Inch)
(Metric)
4. Use the cursor up or the cursor down key to select whether to turn
Remote Diagnosis ON or OFF.
* The asterisk ( * ) in the message display indicates the current
setting.
5. Press the Enter key. The setting for Remote Diagnosis is complete.
Set Fax:
2 in 1 RX
Management
Remote Diag.
Set fax:
2-up RX
Management
Remote diagn. :On
* If you are finished making settings, press the Reset key.
The operation panel will return to the initial mode settings.
:Off
(Inch)
:Off
:Off
:Off
(Metric)
:Off