Kyocera KM-2030 Instruction Handbook Manual page 90

Section 4 Other Features of this Fax
5. If you want to designate the communication for this fax number as
an F-Code Based Bulletin Board Polling Reception, press the
F-Code [SUBADDRESS] key.
> If you pressed the F-Code [SUBADDRESS] key, proceed to
step 6.
> If you DID NOT press the F-Code [SUBADDRESS] key, proceed
to step 9.
6. Enter the subaddress you want to use for this F-Code Based
Polling Reception.
* The subaddress can be up to 20 digits in length and can include
any combination of the numerals 0 - 9.
SubAddress:
6635
Enter SubAddress.
Subaddress:
6635
Enter subaddress numbers
7. Press the Enter key.
Password:
Enter Your Password
8. If necessary, enter the predetermined F-Code password.
* The password can be up to 20 digits in length and can include
any combination of the numerals 0 - 9 and the symbols "
"#". You do not have to enter an F-Code password here if you
agree in advance with the transmitting party not to use one.
* If you DO NOT need to enter an F-Code password, proceed to
step 9.
Password:
3856
Enter Your Password
9. Press the Enter key.
* If the fax number you entered has already been registered for
this operation or too many numbers were entered, an error
message will appear in the message display. In this case, press
the Enter key and the message display will return to a display
that allows you to enter the transmitting party's fax number again.
v :
Enter Destination
10. Select whether or not you want to continue entering other
transmitting fax numbers.
> If you DO want to enter more fax numbers, return to step 4 on
page 4-7.
> If you are finished entering fax numbers, proceed to step 11.
4-8
(Inch)
20 Digits
(Metric)
20 digits
20 Digits
" and
20 Digits
11. If you want to designate a time for the reception to begin,
press the Delayed Tx. key.
* If the maximum allowable number of communications that use
the timer (max: 50) is reached, an error message will appear in
the message display. In this case, press the Enter key and the
operation panel will return to the initial mode settings.
* If you want the reception to begin right away, this step is not
necessary. Proceed to step 14.
(Inch)
12. Press the Enter key.
TX Time:12:00
Enter TX Time
TX time:12:00
Enter transmission time
13. Use the keypad to enter the desired time for the reception to
begin.
* If you want to reset the displayed time to "00:00", simply press
the Stop/Clear key.
TX Time:20:00
Enter TX Time
TX time:20:00
Enter transmission time
14. Press the Enter key. The reception operation will begin
automatically.
* If a time for the reception to begin was designated, the reception
operation will begin when the appointed time is reached.
(Metric)
(Inch)
(Metric)
(Inch)
(Metric)