Turning Dial Confirmation On/Off - Kyocera KM-2030 Instruction Handbook Manual

Turning Dial Confirmation ON/OFF

Dial Confirmation enables the prevention of problems associated
with mistakenly pressing the wrong one-touch, program or group dial
key. When Dial Confirmation is turned ON, you will be able to check
the destination before dialing occurs, thereby preventing your
documents from being sent to the wrong party.
If Dial Confirmation is turned ON...
Pressing a one-touch, program or group dial key will not initiate
dialing. Rather, information such as the destination fax number or the
program registered under that key will be shown in the message
display to allow dialing only after you have checked the displayed
information. (Refer to <Operation with Dial Confirmation turned ON>.)
If Dial Confirmation is turned OFF...
Dialing will start immediately upon pressing the one-touch, program
or group dial key.
* If you want to cancel the procedure part way through, press the
Reset key. The operation panel will return to the initial mode settings.
Set Document
Set original
1. Press the Configure key.
(Inch)
Set Fax:
End
Line Type
TTI
Set fax:
End
TTI
Print report
2. Use the cursor up or the cursor down key to select "Dial Confirm"
["Confirm dial"].
Set Fax:
#Rings(TAD)
#Rings(AutoRX): 2Times
Dial Confirm
Set fax:
Nr of rings
Nr rings-TAD
Confirm dial
3. Press the Enter key.
Dial Confirm:
*On
Off
Confirm dial:
On
*Off
JUL-08-2001 12:00
(Inch)
08-JUL-2001 12:00
(Metric)
(Metric)
(Inch)
:Tone Dial
:Outside P.
(Metric)
:Outside p.
P P
:10Times
(Inch)
:On
: 2Times
(Metric)
:10Times
:Off
(Inch)
(Metric)
Section 6 Various Settings and Registration in this Fax
4. Use the cursor up or the cursor down key to select whether to turn
Dial Confirmation ON or OFF.
* The asterisk ( * ) in the message display indicates the current
setting.
Dial Confirm:
*On
Confirm dial:
*Off
5. Press the Enter key. The setting for Dial Confirmation is complete.
Set Fax:
Set fax:
* If you are finished making settings, press the Reset key.
The operation panel will return to the initial mode settings.
<Operation with Dial Confirmation turned ON>
[Ex.] A single fax number is registered under the one-touch key
1 Press the one-touch key that is registered with the desired fax
number.
(Inch)
v :New York
Press "5" key.
v :New York
Press 5-key
2 Check the destination name and/or fax number shown in the
message display.
3 If the destination IS the one desired, press the key on the
keypad that corresponds to the number indicated in the bottom
line of the message display.
* If you pressed the wrong one-touch key, press the Reset key
and perform the procedure once again from the beginning.
Off
On
#Rings(TAD) :10Times
#Rings(AutoRX): 2Times
Dial Confirm :Off
Nr of rings : 2Times
Nr rings-TAD :10Times
Confirm dial :On
(Metric)
Document:8 1 x11
/
2
Document :A4
(Inch)
(Metric)
(Inch)
(Metric)
(Inch)
(Metric)
6-7