Communication Using The Timer - Kyocera KM-2030 Instruction Handbook Manual

Communication Using the Timer

If you designate in advance the time for a communication to
begin, that communication will be carried out automatically once
the appointed time is reached. You can designate a
communication to be one that uses the timer during the
operation procedure for each of various types of fax
communication available in this fax such as Broadcast
Transmission.
The example in the procedure below is for the transmission of
documents to a single destination using the timer function.
* All transmissions that use the timer will be accomplished in the
Memory Transmission mode even if the fax is currently in the
Direct Feed Transmission mode.
* Each communication that uses the timer can be set to begin at
any minute between 00:00 - 23:59.
* If you want to cancel the procedure part way through, press the
Reset key. The operation panel will return to the initial mode
settings.
Set Document
Set original
1. Set the documents you want to transmit in the DF or on the platen.
* When the documents are set on the platen, it is necessary, after
each page is scanned, to select whether or not you want to
transmit more pages. (Refer to page 1-2.)
Enter Destination
Enter destination
2. Raise the cover plate and press the Delayed Tx. key.
(Inch)
JUL-08-2001 12:00
(Inch)
08-JUL-2001 12:00
(Metric)
JUL-08-2001 12:00
(Inch)
1
/
Document:8 x11
2
08-JUL-2001 12:00
(Metric)
Document :A4
(Metric)
Section 2 Various Functions of this Fax
* You can schedule up to 50 communications that use the timer
(including Standby Transmissions and Interrupt Transmissions)
at one time.
* When 2 communications that use the timer are scheduled to
begin at the same time, fundamentally the communication that
was registered first will be accomplished first. However, even if
it has been registered later, any communication scheduled with
a single location will take priority over a communication to
multiple locations.
* Dial Confirmation is not available for communications that use
the timer.
* If you want to cancel or change the contents of a
communication that is waiting for a start time, refer to
"Editing a Communication in Memory", page 2-13.
v :
Enter Destination
v :
Enter destination
* The letter "T" will be displayed in the first line of the message
display to indicate this is a communication that is using the timer.
* If the maximum allowable number of communications that use
the timer (max: 50) is reached, an error message will appear in
the message display. In this case, press the Enter key and the
operation panel will return to the initial mode settings.
3. Enter the destination fax number.
* You can enter the fax number using the keypad, abbreviated
numbers, one-touch keys or the directory.
v :13579
Enter Destination
v :13579
Enter destination
4. Press the Enter key or the Start key.
TX Time:12:00
Enter TX Time
TX time:12:00
Enter transmission time
T
(Inch)
1
/
Document:8 x11
2
T
(Metric)
Document :A4
T
(Inch)
1
/
Document:8 x11
2
T
(Metric)
Document :A4
(Inch)
(Metric)
2-11