Setting The Default Transmission Mode - Kyocera KM-2030 Instruction Handbook Manual

Setting the Default Transmission
Mode
You can select which transmission mode, Memory Transmission or
Direct Feed Transmission, will be the default setting in this fax.
* If you want to cancel the procedure part way through, press the
Reset key. The operation panel will return to the initial mode
settings.
Set Document
Set original
1. Raise the cover plate and press the Configure key.
(Inch)
Set Fax:
End
Line Type
TTI
Set fax:
End
TTI
Print report
2. Use the cursor up or the cursor down key to select "TX
Mode/Default".
Set Fax:
Set Volume
Scan from ADF :Std size
TX Mode/Default:Memory Tr
Set fax:
Set volume
DF scanning:Std. orig.
TX mode/Default:Memory Tr
3. Press the Enter key.
JUL-08-2001 12:00
(Inch)
08-JUL-2001 12:00
(Metric)
(Metric)
(Inch)
:Tone Dial
:Outside P.
(Metric)
:Outside p.
P P
P P
(Inch)
P P
(Metric)
Section 6 Various Settings and Registration in this Fax
4. Use the cursor up or the cursor down key to select the desired
transmission mode.
* The asterisk ( * ) in the message display indicates the current
setting.
TX Mode/Default:
*Default Feed Transmission
TX mode/Default:
*Default Feed Transmission
5. Press the Enter key. The setting for the transmission mode is
complete.
Set Fax:
Set fax:
* If you are finished making settings, press the Reset key. The
operation panel will return to the initial mode settings.
Memory Transmission
Memory Transmission
Set Volume
Scan from ADF :Std size
TX Mode/Default:Direct Fee
Set volume
DF scanning:Std. orig.
TX mode/Default:Direct Fee
(Inch)
(Metric)
P P
(Inch)
P P
(Metric)
6-15