Installing A Erx14Xx Model Air Filter - Juniper ERX - RELEASE 11.1.X HARDWARE GUIDE 03-23-2010 Hardware Manual

1.
2.
3.
4.
CAUTION: Do not overtighten the screws.
5.

Installing a ERX14xx Model Air Filter

Air filters are hot-swappable; you do not have to power down the system to replace
the filter. The filter is located behind the fan tray bezel located at the bottom of the
front of the system. Remove the bezel to access the air filter. See Figure 46 on
page 92.
Hold the tray horizontally (ERX14xx models) or vertically (ERX7xx models and
ERX310 router) or so that the captive screws point toward you and you can read
text on the labels.
Place the bottom corners of the tray housing in the plastic shelf guides of the
fan tray compartment; push toward the back of the chassis halfway, and stop.
Push the fan tray toward the back of the shelf until it stops.
An electrical connector on the back of the fan tray pairs with an electrical
connector at the back of the shelf.
With an appropriate screwdriver (using a No. 2 Phillips screwdriver, if necessary),
tighten the captive screws.
Alternate between screws when tightening them to ensure that the electrical
connectors at the back of the tray fit tightly.
(ERX14xx model only) Push the top bezel back on the front of the system.
Chapter 8: Maintaining ERX Routers

Installing a ERX14xx Model Air Filter

91