Task 1: Turn Off All Router Power; Task 2: Connect The Grounding Cables - Juniper ERX - RELEASE 11.1.X HARDWARE GUIDE 03-23-2010 Hardware Manual

Figure 26: Power Input Module for ERX14xx Models

Task 1: Turn Off All Router Power

Before starting, you must switch all router power switches to OFF.
To turn off the router, push each power switch to the OFF position.

Task 2: Connect the Grounding Cables

All ERX routers have two grounding studs located in the rear of the chassis, near the
power inputs. Each stud provides grounding for a single power unit.
To ground each power unit:
Chapter 5: Cabling ERX Routers
Cabling the Router for Power
55