Installing A Cable-Management Bracket On Erx7Xx Models - Juniper ERX - RELEASE 11.1.X HARDWARE GUIDE 03-23-2010 Hardware Manual

ERX 11.1.x Hardware Guide
Figure 46: Installing an Air Filter into an ERX14xx Router
To install an air filter:
1.
2.
3.
4.
5.
6.
7.
CAUTION: Do not overtighten the screws.

Installing a Cable-Management Bracket on ERX7xx Models

You can install a cable-management bracket to accommodate cables of different
sizes on ERX7xx models. See Figure 47 on page 93.
92

Installing a Cable-Management Bracket on ERX7xx Models

Ground yourself by using an antistatic wrist strap or other device and connect
it to one of the ESD grounding jacks.
Remove the front bezel by grabbing the edges and pulling straight out toward
you.
Unscrew the two captive screws on the air filter door and swing the door down
to open it.
Remove the old air filter (if present).
Insert the new filter. Be sure the side with the plastic tab is toward you, the tab
is on the bottom, and the mesh side is facing up.
After pushing the filter all the way in, pull down on the plastic tab and then gently
snap front of filter up into the chassis.
Close the door, tighten the captive screws, and snap the bezel on.